Verilink HDM 2182 (880-502925-001) Product Manual - Manual (Page 18)

HDM 2182 Quick Set-Up
2-2 Verilink HDM 2182 User Manual
NOTE: The node controller module (NCM 2000) is usually installed in slot 1
of shelf 1. However, for use with an HDM in a dual-line shelf, the
NCM must be installed in slot 2.
Connect to Craft
Port
Connect the modular (RJ-11) end of the Craft cable (P/N 458-
501788-008) to the port labeled L
OCAL on the front panel of the NCM
module.
Connect the other end of the Craft cable to your PC or terminal. If
your PC has a DB-9 COM port connector, use a standard PC-AT
serial cable to complete the connection.
Terminal
Parameters
Set your terminal, or terminal program, to
• 19.2 kbit/s
• 8 data bits
• no parity
• one stop bit
• no flow control
NOTE: For the most effective and efficient set-up, have all required
planning data such as your intended use, network (telco) provider
specifications, channel and line requirements, circuit
configurations, and other important information handy. For your
convenience, worksheets are provided in the manual, AS2000: The
Basics, Chapter 2—Site Planning .
Logging On 1. Press E NTER to display the pSH+> pSH+> pSH+> pSH+> prompt and type “craft”.
2. Press E NTER to display the NCM Main Menu.
The default password for the NCM gives the user Access Level 2
permissions. For a higher access level, see your NCM 2000 User
Manual.