Verilink HDM 2182 (880-502925-001) Product Manual - Manual (Page 17)

Verilink HDM 2182 User Manual 2-1
Chapter
2
HDM 2182 Quick Set-Up
This chapter provides step-by-step procedures for setting up your
HDM 2182 module. This quick configuration guide makes the
following assumptions:
• You are installing the HDM 2182 and an NCM 2000 module in a
Dual-line Shelf. Two external power supplies will be used.
• You are putting a router on each of the two HSSI ports of the
HDM 2182, each outputting 21.5 Mbit/s of data.
• You are connecting a full T3 to the DS3 port.
NOTE: The NCM 2000 controller module MUST be installed in Slot 2 of the
shelf. The HDM 2182 MUST be installed in Slot 1 of the shelf. When
an HDM 2182 is used with an NCM 2000 in a Dual-line shelf, two
external power supplies are required.
Figure 2-1 Example Configuration
NOTE: These procedures may not match your configuration. Use this
chapter as a guide for equipment installation. Chapter 3 has
complete details on configuration covering all options.
Installation
Do the following before installing the HDM 2182:
•
Install all associated Access System 2000 shelves and power
supplies, as outlined in the AS2000: The Basics manual.
•
Install and test the NCM module first.
Management
Terminal/PC
Full T3
NCM 2000
HDM 2182
DS3 Port
Router
HSSI Port to
Router
HSSI Port to
21.5 Mbit/s 21.5 Mbit/s