Tri Tool 604SB Clamshell - Manual (Page 62)

62
TRI TOOL INC.
92-1197 : Rev. 131230
OPTIONAL DRIVE KITS - IPBS
DRIVE KIT, ELECTRIC (P/N 05-0123)
SPECIFICATIONS
MOTOR SPECIFICATIONS
Voltage Input 115 VAC, 60 Hz
Power requirements 7.5 amp
No load rpm 300 rpm
MATERIAL CUTTING CAPACITIES FOR INTERMITTENT NON-CONTINUOUS USE
Note: The capacity exceeds the maximum wall thickness for small pipe sizes
Severing with standard procedures
.75" (19 mm) wall
Severing and single beveling .50" (13 mm) wall
Severing and double beveling .38" (9 mm) wall
Materials include, but are not limited to: carbon steel, low alloy steel, chrome steel (20%
maximum), chrome/molly alloys (R
c
32 max), austenitic stainless steel, inconel, copper,
aluminum, and copper nickel alloys.
Inconel and some other high-temperature alloys may require special procedures as a
function of wall thickness and type of end preparation.
Contract the engineering department at Tri Tool Inc. for more information.