Tri Tool 604SB Clamshell - Manual (Page 24)

24
TRI TOOL INC.
92-1197 : Rev. 131230
CAUTION:
NOTE:
The Motor Mount reacts the torque of the Air Motor only when the Motor
Hold-down Bolt is in place.
Check that the air supply filter/regulator/lubricator is installed and set properly.
Check for proper alignment of the Feed Sprockets.
Approach of the Feed Pin to the Feed Sprocket
WARNING:
Run the Headstock slowly with the Feed Pin in to insure that the Sprocket is set
right. (Do not run at full speed during the first revolution.)
Ensure that the Feed Pin is aligned correctly or the Feed Pin may break.
Turn on the Air Motor to full speed by opening the Throttle Control Valve.
Deadman Switch Warning
WARNING
DO NOT OVERIDE THE DEADMAN SWITCH ON
THIS UNIT. Locking down, obstructing, or in
any way defeating the deadman switch on this
unit may result in serious injury.