Tri Tool 604SB Clamshell - Manual (Page 11)

11
Model 604SB thru 612SB, Clamshells
92-1197 : Rev. 131230
MAINTENANCE
Clean Up
NOTE:
All components should be cleaned and coated with a light film of oil prior to use.
Use a clean, non-detergent oil, preferably SAE 10 (90 SSU) or lighter.
Air supply for the Model 600SB Clamshell with an Air Motor requires an adequate
filter/regulator/lubricator (FRL) to be used.
The Motor warranty is void if damage occurs from contaminated air or lack of
lubrication.
If the Clamshell is operated in such a manner that the Tool Blocks collect debris
while cutting, the Tool Blocks and the Feed Screws should be cleaned after each
cutting operation.
RECOMMENDED MAINTENANCE SCHEDULE
Daily maintenance when the unit is in operation
Wipe the unit down and spray with rust preventative under severe humidity
conditions.
Visually inspect for loose screws, missing screws, damage, etc.