Tri Tool 604SB Clamshell - Manual (Page 15)

15
Model 604SB thru 612SB, Clamshells
92-1197 : Rev. 131230
HEADSTOCK THRUST
PLATE
HOLD-DOWN
SCREWS
THRUST
PLATE
HOUSING
RACE
MAIN
BEARING MAIN
GEAR
HOUSING CAVITY
NOMINAL
SEVER
LINE
Clamshell Cross Section
Check the Bearing, Housing, and the race on the Gear.
All surfaces should be smooth, without scratches, and they should feature even
wear patterns over the entire surface.
Check the Housing cavity for chips, dirt and/or corrosion.
To reassemble, wipe clean all of the Bearing surfaces and clean the Housing cavity.
Regrease the Gear using a lubricant approved by Tri Tool Inc.
Place the Headstock carefully back into the Housing.
Bolt the Front Thrust Plates back into place.
If the bearing pre-load was properly adjusted before disassembly, then it will still be
adjusted when reassembled.