Teac UH-7000 - Manual (Page 7)

TASCAM UH-7000
7
2 – Names and Functions of Parts
Front panel
1 POWER switch/indicator
Press to turn the unit on/off.
The indicator lights when the unit is on.
2 +48V indicators (INPUT 1/2)
These indicators light when +48V phantom power is being
provided to the ANALOG (BALANCED) MIC IN 1/2 jacks.
CAUTION
Do not connect or disconnect a mic when a +48V indicator
is lit.
3 INPUT 1 knob
Use to adjust the analog input level from the ANALOG
(BALANCED) MIC IN 1 jack and the ANALOG (BALANCED)
LINE IN 1 jack.
4 Level meters (INPUT 1/2)
These show the levels of the analog input signals.
Each level meter has an overload indicator at its top.
5 INPUT 2 knob
Use to adjust the analog input level from the ANALOG
(BALANCED) MIC IN 2 jack and the ANALOG (BALANCED)
LINE IN 2 jack.
6 44.1k, 48k, x2 and x4 indicators
These indicators light according to the currently active
sampling frequency.
7 AES/EBU indicator
This lights when the digital signal input through the
DIGITAL (AES/EBU) IN connector is being used as the
master clock.
8 PHONES jack
Use this standard stereo jack (Φ6.3mm) to connect stereo
headphones. Use an adapter to connect headphones with a
stereo mini plug (Φ3.5mm).
The same signal is output from both the PHONES and
ANALOG (BALANCED) OUTPUT L/R jacks.
CAUTION
Before connecting headphones, minimize the volume with
the PHONES knob. Failure to do so might cause sudden loud
noises, which could harm your hearing or result in other
trouble.
9 MIXER PANEL button
Press to open the Mixer Panel, which you can use to make
various settings, on the display of a computer connected by
USB.
Press when the Mixer Panel is open to close it.
When Analog 1 is set to MIC on the MIXER page, press and
hold this button until the INPUT 1 +48V indicator lights to
provide phantom power to the ANALOG (BALANCED) MIC
IN 1 jack. (See “Microphones” on page 14.)
0 PHONES LEVEL knob
Use to adjust the PHONES jack output level.
When the LINK LINE button is on, use this to adjust the
output level of both the PHONES jack and the ANALOG
(BALANCED) OUTPUT L/R jacks.
q LINK LINE button/indicator
Press this button to turn the link line function on, so that you
can use the PHONES LEVEL knob to adjust the ANALOG
(BALANCED) OUTPUT L/R jacks.
When the link line function is on, this indicator lights.
When Analog 2 is set to MIC on the MIXER page, press and
hold this button until the INPUT 2 +48V indicator lights to
provide phantom power to the ANALOG (BALANCED) MIC
IN 2 jack. (See “Microphones” on page 14.)
CAUTION
• Turning LINK LINE OFF with the button will cause the signal
level at the ANALOG (BALANCED) OUTPUT L/R connectors
to revert to full line level loudness. When turning the LINK
LINE OFF, check and adjust the levels on the currently
playing audio and connected monitoring equipment first.
NOTE
• The link line function on/off setting is retained even when
the unit is turned off.
• The LINK LINE button status is set to ON at the factory,
so the level at the ANALOG (BALANCED) OUTPUT L/R
connectors is determined by the PHONES LEVEL control. If
this is not required, please use the LINK LINE button to turn
the feature OFF.