Teac UH-7000 - Manual (Page 23)

TASCAM UH-7000
23
5 – Mixer Panel Settings
Mixer Panel menu
To reset the mixer settings to their original values, use the
Windows File menu or the Mac TASCAM UH-7000 Mixer Panel
menu.
Windows Mixer Panel menu
Mac Mixer Panel menu
8 Effect Reset
Select this to reset all the settings on the EFFECTS page. (See
“Resetting the effect settings” on page 23.)
8 Mixer Reset
Select this to reset the settings on the MIXER page. (See
“Resetting the mixer settings” on page 24.)
8 ADC Preset
Select this to set the parameter values on the Mixer Panel
screens to values that are useful when using this unit as an A/D
converter. (See “Using the unit as an A/D converter” on page
24.)
8
ADC/DAC Preset
Select this to set the parameter values on the Mixer Panel
screens to values that are useful when using this unit as an
A/D and D/A converter. (See “Using the unit as an A/D and D/A
converter” on page 25.)
8 Save
Select this to save the current Mixer Panel settings in the
memory of the unit. These saved settings will be used by the
unit when it is in standalone mode. (See “Saving Mixer Panel
settings to the unit memory” on page 25.)
8 Close
Select to close the Mixer Panel.
Resetting the effect settings
Follow these procedures to reset all the settings on the EFFECTS
page.
CAUTION
After resetting, you cannot restore the previous settings.
1. In the menu bar, Click “File” on a Windows PC or click
“TASCAM UH-7000 Mixer Panel” on a Mac to open a
pulldown menu, and click “Effect Reset...”
The following confirmation message will appear.
Windows confirmation message
Mac confirmation message
2. Click the “OK” button in the message window to reset the
effect settings to their default values.
The items reset are as follows.
o COMPRESSOR
THRESHOLD, RATIO, ATTACK, RELEASE, GAIN
o NOISE SUPPRESSOR
THRESHOLD, SUPPRESSION, ATTACK, RELEASE
o DE-ESSER
FREQUENCY, DEPTH
o EXCITER
FREQUENCY, DEPTH
o EQ
GAIN for all frequency bands (LOW, MID, HIGH) and MID
FREQ Q
o REVERB
ROOM TYPE, PRE DELAY, REVERB TIME
NOTE
• Click the “Cancel” button to return to the Mixer Panel
without resetting.
• The Effect Reset function does not change the effect on/
off status or the dynamics effect assignment. Use the Mixer
Reset function to restore these settings to their defaults.
See the effect explanations for the default settings of each
effect.