Teac DR-22WL - Manual (Page 17)

TASCAM DR-22WL
17
Messages
The following is a list of pop-up messages.
Refer to this list if one of these pop-up messages appears and you want to check the meaning or
determine the method of dealing with the problem.
Message Meaning and method of dealing with a problem
File Name ERR
DIVIDE caused the number of characters of a file name to exceed 200.
The DIVIDE function adds “_a” or “_b” to the end of the file name. Before
using the DIVIDE function, connect the unit to a computer and edit the
file name to less than 198 characters.
Dup File Name
A file with the same name as that of a file created by
DIVIDE exists in the same folder. The DIVIDE function adds “_a” or “_b” to
the end of the file name. Before using the DIVIDE function, connect the
unit to a computer and edit the file name.
File Not Found The file may be damaged. Check the relevant file.
Non-Supported
The file format is not supported. See “Connecting the Unit to a Computer”
in the Reference Manual for file formats that this unit can use.
Battery Empty The batteries are almost out of power. Replace the batteries.
I/O Too Short
The IN and OUT points are too close together. Set them with at least 1
second between them.
MBR Error Init CARD
The card may not formatted properly or it may be broken. Change the
card or press the F4 button while this message is being shown to format
the card.
Formatting will erase all the data on the card.
Format Error
Format CARD
The card may not formatted properly or it may be broken. This message
also appears if the card was formatted by use of a computer connected
via USB or if an unformatted card is inserted in the unit.
Always use the DR-22WL to format cards to be used with it. Change the
card or press the F4 button while this message is being shown to format
the card.
Formatting will erase all the data on the card.
File Not Found
Make Sys File The system file is missing. This unit requires a system file to operate. While
this message is shown, press the F4 button to create a system file.
Invalid SysFile
Make Sys File The system file required to operate this unit is invalid. While this message
is shown, press the F4 button to create a new system file.
Invalid Card
Change Card
Something might be wrong with the card. Change the card.
Write Timeout
Writing to the card timed out.
Back up files on the card to a computer and format the card.
Card Full
The card has no remaining capacity. Delete unnecessary files or move
them to a computer to make open space.
Message Meaning and method of dealing with a problem
Can't Divide
The selected division point used when DIVIDE was performed is not
appropriate. (It is too close to the beginning or end of the track.)
Max File Size
The file is larger than the designated size or the recording time exceeded
24 hours.
File Full
The total number of folders and files exceeded 5000. Delete unnecessary
folders and files or move them to a computer.
Card Error The card could not be recognized properly. Change the card.
File Protected The file is read only and cannot be deleted.
No Card No card is in the unit, so recording is not possible.
No PB File There is no file that can be played back. The file may be damaged.
No MUSIC File There is no playback file, so DIVIDE cannot be executed.
If any other error occurs, turn the unit off and restart it.