Super Systems 9130 Series - Manual (Page 66)

Series 9130 Operations Manual Rev - 65
[A]CarbPro v3.5 [T]9200 LP3 SSi M4L User 2
[A]CarbPro v3.0 9100 LP2 SSi X5/Timer User 3
CarbPC Eurotherm 2704 LP1 SSi SPUD User 4
[A]9200 LP1 Eurotherm 2704 LP2 SSi AIB3 User 5
IR Base Eurotherm 2704 LP3 SSi H2 Cell User 6
MGA VC Base 1 Flow Meter Short User 7
SSi 7EK VC Base 2 SSi O2 Remote User 8
[T]Yokogawa 750 VC Base 3 SSi Dual Motor Board User 9
[T]Honeywell UDC3300 VC Base 4 SSi AC E User 10
[T]Dualpro LP1 Modbus AIPC Yokogawa 750E User 11
[T]Dualpro LP2 Modbus SSi 7SL Mod Mux User 12
[T]Dualpro LP1 MMI AEC Flow Board Dualpro E Modbus User 13
[T]Dualpro LP2 MMI UMC800 LP1 Dualpro E MMI User 14
[T]Eurotherm 2404 SSi Quad AO1 Carbpro E v3.5 User 15
User 16
Address
This value allows the user to select the address that corresponds with the controller selected, with a range
of 0 to 249.
Port
The options for this field are: Slave 1, Slave 2, RS-232, IP Address 1, IP Address 2, IP Address 3, IP Address
4, Passive, or Slave 3/RS-232.
Slave 1 – terminals 5(-), 6(+)
Slave 2 – terminals 22(+), 23(-)
RS-232
Zone Assignments
A zone assignment on the 9130 vacuum
controller allows the recipe programs to
change setpoints on all slave instruments of
a multi-zone furnace (up to 10 zones).
*Only used when running recipes
*Slave Instrument Setup must be configured
prior to Zone Assignment setup
** Temperature zones link instruments to Temperature Setpoints
Assignments
The zone assignment number, with a choice of Assignment 1 through Assignment 10.
Temp Instrument
The temperature instrument number, with a choice of: Loop 1, and Instrument 1 – Instrument 25.
Temp Zone Number
The zone within which the temperature setpoint change is desired, with a range of 0 to 10.
Default Zone Offset, temp
This is the default zone offset for temperature, with a range of –32000 to 32000.