Smithy Ez-Trol2 - Manual (Page 60)

N41Y.325
N42X2.025
N43Y1.675
N44X.725
N45Y1.075
N46X.525
N47Y.125
N48X2.225
N49Y1.875
N50X.525
N51G1G40X.525Y1.075
Block 51 moves the machine to X.525 and 1.075. This move causes the tool radius compensation to
be interpolated out of the tool path during this move (G40)
N52G0Z1.M09
Block 52 moves the tool 1 inch above the top surface of the work piece and turns the coolant off
(M09).
N53X1.4Y1.
Block 53 moves the machine to coordinate X1.4 Y 1.
N54Z-.6
Block 54 plunges the end mill to Z -.6.
N55G1Z-.7F1.08M08
Block 55 feeds the end mill to Z-.7 at the feed rate of 1.08 and turns the coolant on (M08).
N56G1G41X1.4Y1.D2F115.51
Block 56 moves the end mill in a line at 114.51 inches per minute. Simultaneously, tool cutter diam-
eter compensation is turned on. D2 is the diameter value for tool number 2 in the tool table. The
end mill is moved to the intersecting coordinate of X1.4 Y1. Tool radius compensation value is inter-
polated into the tool path over the course of the move.
N57G3X1.4Y1.I-.025
Block 57 begins the cut of the circular pocket. G3 moves the cutter in a counterclockwise arc. The
cut begins and ends at X1. Y1. I-0.25 represents the distance from the center of the end mill to the
center of the circle. This first cut moves in a spiral.
N58G1X1.6
Block 58 moves the end mill in a straight line to X1.6.
◗
SmithyCNC EZ-Trol II Control System
54 | Toll Free 1-800-476-4849