Smithy Ez-Trol2 - Manual (Page 13)

CONTROL SYSTEM COMPONENTS
& FUNCTIONS
The Smithy EZ-Trol II is equipped with 2 control panels located on the operator’s side of the box
(opposite the side with the control cables.) These switches are identified below and we suggest that
you become familiar with these switches before operating your machine.
COMPUTER CONTROL PANEL
This panel works and functions the same as a personal computer. The panel controls are connect-
ed to the motherboard of the control system.
Figure 4.1 EZ-Trol II Computer Control Panel
1. USB Ports (2) - Used for loading programs into the EZ-Trol II system.
2. Power Light – Indicates that the control is turned on.
3. Disk Light – Indicates that a program is reading or writing to the internal solid slate disk.
4. ON/OFF Switch – Turns power on and off to the comtrol.
5. Clear – Restarts (reboots) the contol.
4
1
2
3 4
www.smithycnc.com | 7