Smithy Ez-Trol2 - Manual (Page 17)

CONNECTING EZ-TROL II
Smithy lathes and mills are equipped with the required cables and connectors for connecting the
EZ-Trol system to the machine. Instructions for connecting the conrol to each SmithyCNC machine
follows below:
CONNECTING THE EZ-TROL II CONTROL BOX TO THE BED MILL
Step 1: Connect the Power Supply Box to the SmithyCNC 1240 Bed Mill
The EZ-Trol II Control Box is shipped with seven (7) 6’ cables that connect the junction box locat-
ed at the back of the 1240 bed mill to the power supply box. Each cable has identifying tags that
correspond with labels on the junction box and power supply box.
Connect the corresponding plugs, first to the sockets on the junction box on at the back of the bed
mill, and then to the proper sockets on the power supply box. It is advisable to start from the upper
left moving to the right and down.
Please make sure that you have read all the labels before proceeding.
Figure 5.1 1240 Bed Mill Connected to the Power Supply Box
Step 2: Placing the Power Supply Box
The system is designed so you can place the power supply on the floor beside or behind the mill.
The cords are long enough for you to have some flexibility in positioning the box.
5
www.smithycnc.com | 11