Smithy Ez-Trol2 - Manual (Page 53)

Operations can also be rearranged by moving it up or down the list. You can also delete any
operation. To do so simply right click on the operation name on the Operation List and a menu will
be shown for you to pick the desired action. Remember that the gcode generated will be in the same
order as with the Operation List.
Figure 12.11 Change of Operation Order Screen
When you are done adding Wizard Operations you can then save all information to a file for use
later.
Figure 12.12 Save Button Menu
You can also send the generated G-code to the Auto Tab right away ready for machining. Before
machining make sure that the tools you have listed in the Wizard tab is similar to what you have in
the Settings tab. The G-code that is generated is saved automatically with a system generated file-
name based on the time theh file was generated. It is this format, YYYYMMDDHHMM.ng. It is also
deleted automatically when exiting EZ-Trol II.
www.smithycnc.com | 47