Smithco Spray Star 1600P (sn 0979 – 0991) Parts & Service Manual - Manual (Page 6)

Ser
vice
4
MAINTENANCE
Before servicing or making adjustments to machine, stop engine and remove key from
ignition. When servicing the spray pump or filter all control valves must be shut off if there is
liquid in the tank.
Use all procedures and parts prescribed by the manufacturer's. Read the engine manual
before operation.
The suggested maintenance checklist is not offered as a replacement for the manufacturer’s but as a supple-
ment. You must adhere to guidelines established by manufacturer for warranty coverage. In adverse conditions
such as dirt, mud or extreme temperatures, maintenance should be more frequent.
LUBRICATION
Use No. 2 General purpose Lithium Base Grease and
lubricate every 100 hours. The Spray Star 1600P has 7
grease fittings.
A. One on the rod end of hydraulic cylinder.
B. One on each the right and left spindles.
C. One on the front axle.
D. One on clutch idler arm.
E. One on each end of the drive line.
AIR CLEANER
1. Loosen cover retaining knob and remove cover.
2. Remove precleaner from paper element.
3. Check paper element. Replace element as necessary.
4. Wash precleaner in warm water with detergent. Rinse precleaner thoroughly until all traces of detergent
are eliminated. Squeeze out excess water (do not wring). Allow precleaner to air dry.
5. Saturate precleaner with new engine oil. Squeeze out all excess oil.
6. Reinstall precleaner over paper element.
7. Reinstall air cleaner cover. Secure cover with cover retaining knob.