Smithco Spray Star 1600P (sn 0979 – 0991) Parts & Service Manual - Manual (Page 133)

131
Accessories
OPERATOR'S PROTECTIVE ENCLOSURE INSTALLATION
1. Remove cab from shipping pallet. Carefully remove band holding doors closed and save. Bands must be
used to keep doors closed when in transport.
2. Park Spray Star on a level surface, set park brake and remove key.
3. Remove two screws from rear of engine cover, furthest from seat.
4. With three to four people, lift cab over front of machine and move it to rear, until lower cross member of
cab comes into contact with front bumper. Lower cab until front rests on tow hook and back on the rear
engine cover.
5. Center cab left to right. Clamp cab to front bumper of Spray Star. Make sure that it is still centered. Using
mount holes in cab as guides drill two 13 /
32
" holes through both walls of bumper.
6. Bolt cab to bumper. On left side of Spray Star place loom clamp with loop pointing down and a 3 /
8
" washer
toward outside, put a 3 /
8
- 16 x 2 1 /
2
bolt through with lock nut on inside. Do the same without loom clamp
on right side.
7. Use holes in rear of cab as a guide and drill a 13 /
32
" hole through rear engine cover and both walls of tubing
each side. Make sure cab is still centered before drilling.
8. Put washers on top and run bolts down through with lock nuts under tubing. Tighten all four bolts.
9. Find red wire that comes out bottom of left front support tube on cab. Place a 8853 slide-on connector on
the end of wire. Route wire through loom clamp, under the floorboard, in with wire harness and hoses up to
the fuse block.
10. Plug wire into fuse block on an empty terminal and place a 30 Amp auto blade type fuse 33-273 into same
position in fuse block.
11. Check to see that both the wiper and blower work. If not check ground and fuse.
When handling the filter, to insure safety of yourself and others follow all accepted practices
of chemicals that the filter has been exposed to.
12. The filter element is located in front and above the driver. It is serviced from the outside of cab. To service
filter, remove from cab.
13. The filter can be taken apart for cleaning and washed in soap and water.
14. To reassemble filter, place orange and white 1 1 /
2
" dust lock pad into case first with orange side next to the
screen, then place polysord carbon and retainer.
15. Place filter back into cab with polysord carbon facing up and screen down, tighten clamps.
Cab
Hose Reel
Foamer
Boom
Manifold Ball
Valve
Spray System