Skutch Electronics BA-1000-A V4.00 Technical Reference Manual - Manual (Page 6)

Version 4.00 Page 6
" Remote Outgoing Message recording and
playback
.
" Remote Notification Number
programming, enabling or disabling
.
" Remote START GROUP programming.
" Change between Idle and Answer modes.
Power Fail Friendly
If the power fails, the BA-1000-A will
remember its exact mode. So, when power is
restored, the BA-1000-A will resume where it left
off; whether dialing or waiting for calls to come in.
Other Features
" Programmable Ring Delay from 1 to 12,
or Toll Saver mode.
" Announce ONLY Mode .
" Voice Controlled Recording.
" Maximum Record Time Limit ,
adjustable from 10 seconds to 4 minutes,
or unlimited.
" CPC Disconnect (ON/OFF).
" Dial Tone disconnect (ON/OFF)
" Auto Disconnect on Local Pick Up, the
unit automatically disconnects when you
pick up a local phone.
" Disk FULL message. A special message
plays when the BA-1000-A runs out of
message storage space: "System full
please try again later".
" Four digit user programmable remote
programming access code .
" Automatic clock control can be set to let
the unit turn itself on during non-
business hours.
" 128, 32 digit, notification phone numbers
can be user programmed.
Installation
! Location
When selecting a location for the system, the
following conditions MUST be avoided:
Temperatures above 95 ° F.
Temperatures below 65 ° F.
Carpeted areas that produce Static Electricity.
High dust/tobacco smoke areas.
Exposure to direct sunlight.
The SYSTEM and the POWER CUBE should
be located in a well ventilated area.
! Power
The SYSTEM can be used on a three-prong
grounded 110VAC power outlet. This is needed for
proper protection of the unit's circuitry. Power
circuits that are used for any heavy equipment such
as large freezers, blowers, heaters, copiers, or any
electrical equipment that contains large motors,
should be avoided. Heavy electrical equipment can
cause power glitches over the power line which
could interfere with the operation of the system. If
your power lines are excessively noisy a power filter
MIGHT solve the problem.
! Phone Connection
The system's telephone line requirements are
the same as a standard telephone. Its connection to
the telephone line is the same as any NORMAL
single line telephone that you could buy at any
department store.
! Business Telephones
This system is not compatible with modular
jacks used for multi-line ELECTRONIC PHONE
SYSTEMS. To connect the SYSTEM to this type of
phone system, an RJ-11 jack must be ordered from
your local telephone company. It should be noted
that when the BA-1000-A is used, the line indicator
lights on the phone system will not show the line as
being used.
! Single Line Phones
If you have a single line phone it is probably
connected to a small modular jack. Simply unplug
the phone and plug the system in. If you wish to
have both the phone and the system connected at the
same time you can plug the phone into the PHONE
jack on the back of the BA-1000-A.
! Order A Phone Jack
If you need to order a jack from the telephone
company, you will need the following information: