Skutch Electronics BA-1000-A V4.00 Technical Reference Manual - Manual (Page 11)

Version 4.00 Page 11
! Exiting Auto Mode
To exit Auto Answer mode, and return to IDLE
mode, simply press the ~ ~ ~ ~.
Local Playback
This mode is used to play back all inbound
messages. The unit will play back Urgent calls first,
then new calls, followed by all saved calls.
Press: ~ ~ ~ ~.
Wait 5 seconds.
Press and HOLD DOWN
4 4 4 4 until you hear a
Beep, then release the 4 4 4 4.
When the first message starts playing the
display shows:
Type of call┐ ┌Message Number
New 00001
11/05 01:10 pm
Date received┘ └Time received
After the message has finished playing the
display shows:
1=Erase Message,
3=Save, 5=Replay
At this point the system will wait until you
select one of these functions or ~ ~ ~ ~ to exit.
! Exiting Playback
After the last message has been played, the unit
will return to the IDLE mode. You may also press
the
~ ~ ~ ~ to exit at any time.
Remote Playback
This mode is used to remotely access your
messages from any touch tone telephone.
Call the BA-1000-A from a touch tone phone.
While the message is playing, enter * * * *, then
the PIN number then # # # #. NOTE: When the unit
is in ON CALL mode or voice mail box mode, it
will require you to enter your
PIN number then # # # #;
for all other modes, you enter the remote access PIN
then # # # #.
The system will tell you how many Urgent
messages you have, then it will play them back, one
at a time. For each message, you will hear the date
and time, the message came in (spoken to you), the
message that was left, then instructions as follows:
"1 to Erase, 3 to Save, or 5 to Re-Play".
Now you can enter 1 1 1 1 to erase this message,
3 3 3 3 to save this message for later playback, 5 5 5 5 to
play this same message again or * * * * to force the
system to end the call without further changes.
After your command, the unit will play the next
message. Once the system has played back all
Urgent messages, the unit will say; "All Messages
reviewed". If the unit BEEPS after this statement,
this indicates that the system currently has other
New and/or Saved messages. You can review the
New/Saved messages by pressing
0 0 0 0 within 5
seconds of the BEEP; if you don’t, the system will
hang up.
Remote
Programming
This mode is used to remotely record or test
your outgoing message , enter/erase/enable/disable
your Notification phone numbers , or change your
START GROUP parameter.
Call the BA-1000-A from a touch tone phone.
While the message is playing, enter the
following:
* 0506 #
* 0506 # * 0506 # * 0506 #
NOTE: When the unit is in ON CALL mode
or voice mail box mode, it will require you to enter
your
PIN number then # # # # after the above code in
order to access remote programming mode.