Skutch Electronics BA-1000-A V4.00 Technical Reference Manual - Manual (Page 13)

Version 4.00 Page 13
If the BA-1000-A detects a call to be Urgent, it
will immediately hang up and start searching for
you. It will start by dialing the first pre-programmed
notification number, and will keep calling numbers
until the Urgent call has been reviewed. The BA-
1000-A will keep calling the list of notification
numbers over and over until either: the urgent
message is retrieved or it has called all of the
numbers 20 times each, whichever comes first.
Once the system contacts you, it says; "I have an
urgent message from your office. Enter the access
code". Once you enter the
access code the BA-
1000-A will play you the urgent message.
Setup Mode
Setup Mode is used to set the clock and to
change various system parameters of the BA-1000-
A. It should be noted that changing the system
parameters WILL effect the operation of the
machine. You should not change any parameters
that you do not understand or it might cause a
malfunction in the operation. Call technical
support if you are not sure!
Enter:
888 888 888 888
! Set CURRENT Time
The first option in System Setup is to set the
current time. The display will show the following:
Set CURRENT Time
1=Change #=Next
You can press then release 1 1 1 1 to change the
current time or # # # # to proceed to the next option.
You can press then release ~ ~ ~ ~ to exit
setup mode.
Set The Current Day
If you press then release 1 1 1 1 to change the
time; the display shows:
Enter day, 1 – 7
#=Sunday
The current day will be shown in the bottom of
the display. To change the day, press then release
the corresponding number followed by
# # # #; i.e. 1 1 1 1
for Sunday, 2 2 2 2 for Monday, etc.
Set The Current Date
Now the display will show:
-- Enter Date –-
# = 01/01/1980
The current date will appear in the bottom of
the display. You can enter a new date followed by
#
# # #, or just press then release # # # # to keep the
current date.
Set the Current Time
Now the display will show:
-- Enter time --
- # = 12:00 pm –
The current time will appear in the bottom of
the display. You can enter a new time followed by
#
# # #, or just press then release # # # # to keep the
current time. You can change between a.m./p.m. by
pressing then releasing the
* * * *.
! Access Code=1234
This is the general access code used to remotely
retrieve messages left on the system, by modes 0, 1
and 3. The display will look as follows:
Access Code=1234
1=Change #=Next
You can press then release 1 1 1 1 to change the
access code, followed by the # # # #, or press then
release # # # # to proceed to the next option. You can
press then release ~ ~ ~ ~ to exit setup mode.
! Play Only= Off
This controls Announcement Only mode.
When ON, the unit will answer the phone, play the
outgoing message, and will hang up without
recording a response. The display will look as
follows: