Skutch Electronics BA-1000-A V4.00 Technical Reference Manual - Manual (Page 16)

Version 4.00 Page 16
! Set AUTO CLOCK
This option allows you to set the starting and
stopping times, for each day of the week, that the
system uses to enter/exit clock controlled auto
answer mode; the display will look as follows:
Set AUTO CLOCK
1=Change #=Next
You can press then release 1 1 1 1 to change the
times or # # # # to proceed to the next option. You can
press then release ~ ~ ~ ~ to return to Total
Calls . The default times are to start at 5:00 p.m. and
end at 8:00 a.m.
Select The Day To Change
Press then release 1 1 1 1 to change the time; the
display shows:
Enter day, 1 – 7
#=Sunday
To change the auto times for a day, press then
release the corresponding number followed # # # #;
example, enter 1 1 1 1 for Sunday, 2 2 2 2 for Monday,
etc.
Set The Start Time
This is the time you want the system to activate
itself (normally this is your quitting time). Now the
display will show:
Answering START
- # = 05:00 pm –
Now you can enter a new start time followed by
# # # #, or just press then release # # # # to keep the
current time. You can change between a.m./p.m. by
pressing then releasing the
* * * *.
Set The Stop Time
This is the time you want the system to return
to Idle Mode (normally this is the time you start
work). Now the display will show:
Answering STOP
- # = 08:00 am –
Now you can enter a new stop time followed by
# # # #, or just press then release # # # # to keep the
current time. You can change between a.m./p.m. by
pressing then releasing the
* * * *.
Now the system will return you to the initial
dialing times screen so you can select another day to
adjust (you will notice that it already shows the next
day in the display). To exit from this mode, press
then release
~ ~ ~ ~ to return to Total Calls .
! Remote Code=0506
This is the access code used to remotely
program the unit or record/test your outgoing
message. The display will look as follows:
Remote Code=0506
1=Change #=Next
You can press then release 1 1 1 1 to change the
remote code, followed by the # # # #, or press then
release # # # # to proceed to the next option. To exit
from this mode, press then release ~ ~ ~ ~ to
return to Total Calls .
! Factory Reset
This option is provided to restore all of the
setup parameters back to the factory defaults. This
should only be used when operation of the system
has been messed up because the parameters were
changed. The display will show the following:
Factory Reset
1=Reset #=Next
Press then release 1 1 1 1 and it will show the
following for 1 seconds:
Loading Defaults
- Please Wait –
The system will then show the following:
Factory Reset
1=Reset #=Next
You can press then release 1 1 1 1 to reload the
defaults, or press then release # # # # to proceed to the