Skutch Electronics PARS v3.2X - Manual (Page 4)

- 4 -
Uses:
* Appointment Reminders
* Appointment Cancellations due to Office Closure, medical emergency, weather, etc..
* Flue shot, yearly check up reminders.
* Rescheduling of "NO SHOWS".
Save Your Packing Foam Pads!
Please save the two foam end pads that were shipped with your system. You will need these if you ever
have to ship the system back to us for repair. These pads provide maximum protection during shipping.
They were custom made specifically for your PARS system.
Installation:
The PARS comes with the following accessories:
1- Microphone
2- Power Supply
3- Telephone cord
4- Dialer System CF Card.
Location:
When selecting a location for the PARS dialer the following conditions MUST be avoided:
1- Temperatures above 95 degrees F.
2- Temperatures below 65 degrees F.
3- Carpeted areas that produce Static Electricity.
4- High Dust or smoky areas.
5- High humidity areas.
The PARS dialer should be located in a well ventilated area. Make sure that both a power outlet and a
telephone jack are within six feet of the installation site.
Power:
CAUTION: Do not connect or disconnect the POWER SUPPLY directly to/from the back of the PARS
DIALER while the POWER SUPPLY is connected to 115VAC power. You MUST remove the POWER
SUPPLY from 115VAC first! Failure to follow this warning could cause electrical damage to your PARS
system.
The PARS dialer must ONLY be used with the POWER SUPPLY that is supplied with the unit. The
POWER supply is designed to work on a 110-120VAC @ 50/60Hz power. Power circuits that are used for
heavy current equipment such as large freezers, blowers, heaters, copiers, or any electrical equipment that
uses large motors, should be avoided. Heavy current electrical equipment can cause power glitches over
the power line which could interfere with the operation of the system.
Telephone Connection:
PARS's telephone line requirements are the same as a standard single line telephone that you would use at
home, or the same as a fax machine. If the system is going to be dialing all day, we recommend that you
connect it to a non published telephone line that is dedicated for this specific application.
Note: The PARS dialer is not compatible with modular jacks used for multi-Line ELECTRONIC PHONE
SYSTEMS. If a standard single line home phone will not work in the jack, neither will the PARS dialer.