Sierra Video SVG Multi-Viewer - Manual (Page 74)

SIERRA VIDEO
64
Network Configuration
Change IP address
User can modify the SVG's IP address. If modified successfully, the system prompts a
message box labeled "Network has been configured successfully, please turn off the
power and restart the device again.” Restart the device, enter the new IP address into
your browser URL and the web software will be opened.
Change NTP IP for NTP Timing
Configure the “NTP Server” to be the IP address of NTP server for NTP timing. The NTP
server and SVG should be in the same network segment.
Upgrade firmware of system
User can also upgrade the system firmware in this section. Before the upgrade, any anti-
virus software and firewall have to be closed to make sure that the upgrade data is
transmitted to the SVG system without rejection. Windows 2003, Windows XP, Windows
Vista and Windows 7 system are strongly recommended to upgrade the system with
Internet Explorer, but you can use your preferred browser.
Set all channels to input inner test signal without waveform display before initiating the
upgrade. This will take less time to upgrade the system than active video inputs.