beautypg.com

Sierra Video Ponderosa 3G Series Routing Switcher User Manual

Page 28

background image

SIERRA VIDEO

22

To set IP parameters using the serial port

;

To set the IP address:
Connect to the Ctl 2 port using a terminal emulator such as HyperTerminal or Hyper Access.
Baud Rate 115200
Data Bits 8
Stop Bit 1
Parity None
Flow Control X-ON/X-OFF

Default settings:

Master CPU:
IP Address 192.168.1.200
Subnet Mask 255.255.255.000
Gateway Address 0.0.0.0
Telnet Port

10001 or 12000


Slave CPU (optional):
IP Address 192.168.1.201
Subnet Mask 255.255.255.000
Gateway Address 0.0.0.0
Telnet Port

10001 or 12000


Press enter to enter the Terminal Application.
Press “Ctrl W” to access the router configuration screen.
Press "B" to access the "Available Variables" screen.
Press "11" to change the IP address variable and enter the new IP address.
When complete press "12" to access the Subnet Mask Variable and enter the new subnet mask.
When complete press "18" to access the Gateway address Variable and enter the new Gateway address.
after making these changes press the escape button and then press Ctrl W, V
This will save the new settings into persistent memory.
When complete press escape.
If setting up a Redundant CPU you need to switch to the redundant CPU by pressing "T"
And answer "Y” to the following question.
Do you want to switch to the standby processor? [N]
Once the switch to the slave is complete repeat the above steps for the
slave processor then switch back to the master processor when complete.

DO NOT MAKE ANY OTHER CHANGES TO THE AVAILABLE VARABLES WITH OUT CONSULTING
WITH THE FACTORY.

Note:

The Ethernet port accepts HOST protocol commands to switch the router. See the
section of this manual on Protocol for information on Host protocol commands.

*If your server is capable of IP reservations by the MAC address you can enable the DHCP option. It is
advisable to contact the Factory for further information regarding this feature.