Seaward SafeCheck 8 - Manual (Page 31)

How to use Setup
30
ROLL PRINTER
This allows the user to define the roll printer to be used with the
Safe Check 8. For barcode printing with the Seaward Thermal
Printer (283A954) set to SEAWARD (283A954).
Change Password
It is possible to Password protect the TEST SEQUENCE EDITOR
and the SYSTEM CONFIGURATION
If you currently do not have password protection you will be asked to
enter a new password twice, once for confirmation.
If you currently do have password protection then you will be asked
for the old password before entering a new one, again you will be
asked for the new password twice.
To clear the password protection simply press Enter when asked for
the new password. Or set the field to ‘blank’ (i.e. all spaces) if a
password was previously set.
Set Brightness
You can set the Brightness of the display. Use the cursor keys to
change the Brightness, once the Brightness is set press the Green
button to accept the changes. Press the Red button to abort any
changes made.
Factory Settings
It is possible to reset the Safe Check 8 to the settings which were
configured from new. This option will first ask you if you are sure,
select Yes to reset or No to abort.
Caution
This will restore all TEST SETTINGS to the default levels