Seaward SafeCheck 8 - Manual (Page 10)

Switching on the tester
9
Switching on the tester
The Tester is supplied with a moulded 3 pin plug to ensure that it is
safely wired and ready to go from receipt.
The Tester must be powered by a 230V or 110V supply, which
includes a protective Earth connection, via a correctly wired 3 pin
plug & socket.
Before switching on make sure the guard switch or guard switch link
plug is fitted to the guard switch socket in the back panel. (see
Chapter 7 Accessories for details of the guard switch.
When switched on, the Tester will carry out a short self-test
procedure (approximately 2 seconds). During this test, the following
screen will appear:-
The hardware and software versions are displayed during the self-
test. This is useful information to quote should any telephone advice
or servicing become necessary.
HARDWARE VERSION 1.00
SOFTWARE VERSION 1.00