Seaward 220 PrimeTest - Manual (Page 9)

Operating Instructions
Primetest 220
2
The following symbols are used in these operating
instructions and on the PrimeTest 220.
Warning of electrical danger! Indicates instructions
must be followed to avoid danger to persons.
Important, follow the documentation! This symbol
indicates that the operating instructions must be
adhered to in order to avoid danger.
This symbol on the PrimeTest 220 indicates that the
unit can safety test Class II equipment. The
PrimeTest 220 is not double insulated.
This symbol on the PrimeTest 220 indicates that the
unit can safety test Class I equipment.
This symbol on the PrimeTest 220 indicates the
built in fuse.
2.0 Safety Notes
This PrimeTest 220 has been built and tested in
accordance with:
BS EN 61010 part 1.
BS EN 61557 part 1, 2, 4 and 10.
The PrimeTest 220 has left the factory in a perfectly safe
state. To maintain this state and ensure safe operation of
the unit, all notes and warnings in these instructions must
be observed at all times.
This instrument may be used on electric
circuits, which comply to over voltage category
II. The symbol warns the operator that a
dangerous voltage is connected to the unit.
PrimeTest 220 REV 1 5/12/05 1:52 pm Page 7