RJS Inspector D4000 Laser (FIRMWARE version A.05 and Earlier) - Manual (Page 60)

Appendix J Operator ’ s Guide
RJS, Minneapolis, MN 002-5568 54
(You can have many records (like the record above), stacked in a file. The start character for the file is an
ASCII STX (hex 02), i.e. ALT-2. The end character for the file is an ASCII ETX (hex 03), i.e. ALT-3 )
Sample Database
STX
"01234567890512","UPC A+2","SAMPLE # 1",
"9876543212344","EAN 13","SAMPLE # 2",
"01234565","UPC E","SAMPLE # 3",
"0192837243645","EAN 8+5","SAMPLE # 4",
"123ABCDEF456","CODE 3of9","SAMPLE # 5",
"987WXYZ","CODE 93","SAMPLE # 6",
"01928374","CODE I 2 OF 5","SAMPLE # 7",
"567RSTUVW","CODE 128","SAMPLE # 8",
"124589","CODABAR SYMBOL","SAMPLE # 9",
"00123456789012345675","CC 128 SYMBOL","SAMPLE # 10", ETX
Database Download
Step 1)
Plug the cable (002-2979) into the serial communications port
of an IBM compatible PC/AT/386/486 computer.
Step 2) Plug the connector of the cable into the
Laser Inspector unit.
Step 3) Turn on the Laser Inspector by pressing the ON
switch or pressing the scanner trigger.
Step 4) Using the MODE command of MS-DOS, enter
the following:
MODE COMx:9600,n,8,1
Where x is the number of the communications port to be used.