RGBLink DXP D1616 User Manual - Manual (Page 25)

2. Hardware Orientation
DXP D1616 Front Panel
DXP D1616 User Manual 25
indicator is on. (DXP D1616 V1.1 can not support this function)
Com: When connect device for cascade, the green Com indicator is on.
IR Receiver
Can receive the infrared signal.
Function Button
[1] ~ [16] Digital button: Selection button for input and output channel, used
to set video signal input and output channel, also, can be used to number
choice of save or call saving modes.
[MENU]: Menu and up arrow button. Push the button to enter into the menu
items. In menu state, push the menu to exit the current state to the previous
state.
[NEXT]: Down arrow button.
[TAKE]: Confirm button.
[ALL]: Distributor selection button, it will output one input to all outputs.
For example: When switch off the ―AUTO TAKE‖ function, push the [ALL]
→ [5] → [Enter] button, it will distribute the input of channel 5 to all outputs.
[SAVE]: Save button, save all current switching channels and current
states, the buttons [1]~[16] in output channel correspond to save 1~16, and
the buttons [1]~[16] in input channel correspond to save 17~32, a total of
32 kinds of saving modes.
For example: Push the [SAVE] button, then push the [6] button in output
channel, the current state will be saved to SAVE 6.
Note
If power fails suddenly, the device will
automatically save to the current using mode,
and do not need reset when power on.
[LOAD]: Load button, load all the saved modes, the buttons [1]~[16] in