RGBLink MVP 320 User Manual - Manual (Page 45)

MVP 320 User Manual 45
15. User management
Set the limit of operators; through this setting, the loading code, and user can be set
for the controlling software.
16. Setting the RTC time, change the time in ―current time‖.
Base map, add pictures according to the customer requirement. Click the ―base map‖,
the following will be shown, select ―bitmap file‖ and then click ―confirm‖ to upload the
pictures. The picture is 24bit. After uploading, the controller needs to be reopened.
The base map either be shown on the whole output mix or the some part zone. See
below, the grey zone is the displaying area of base map.
Select the ―base map enable‖.