RGBLink MVP 320 User Manual - Manual (Page 21)

MVP 320 User Manual 21
7．Installation of the Equipment
The equipment should be installed on the stable, steady and even working
table or in the standard stand, cabinet and chassis.
8．Safety Notes
8.1 The high voltage exists in the equipment, non-professional staff is not
allowed to open the equipment, so as to avoid that danger occurs.
8.2 That place such container as is filled in with liquid on or near the
equipment is prohibited.
8.3 That the equipment is close to fire is prohibited.
8.4 Sufficient ventilation should be ensured. A space of 20CM should be
maintained and kept between the front and back panel of the equipment.
8.5 The power plug should be unplugged in case of that thunder and
lightning occurs or it is not being used for a long time.
8.6 In order to avoid that damages will be caused to the equipment, the
vents of the equipment should not be blocked.
8.7 Do not place the equipment on the place near liquid.
8.8 Please place the power cable properly to avoid damages.
8.9 In case of any of the following situation occurs, the power should be
unplugged immediately and the problem should be handed over to
professional staff to handle.
8.9.1 Where the plug power cable is damaged, wore or tore.
8.9.2 Where liquid plashed into the equipment.
8.9.3 Where the equipment fell or chassis damaged.
8.9.4 Where obvious abnormal function or performance changes occurred
to the equipment.
Note: It is not suitable for non-professional staff to carry out commissioning. Train or
guidance made and given by the professional staff must be accepted when using
the equipment. Please read this instruction carefully before using the equipment,
and the instruction should be kept properly for future and further using.