REMKO ATY 261 DC - Manual (Page 6)

Operation
Infrared remote control
The infrared remote control sends
the programmed settings over
a distance of up to 6 m to the
receiver of the indoor unit. Data
will only be received correctly
if the remote control is pointed
at the receiver and no objects
obstruct the transmission path.
First insert the batteries supplied
on delivery (2 x type AAA) into
the remote control. To do so,
pull off the flap of the battery
compartment and insert the
batteries according to their
polarization (see marks).
The indoor unit is easily operated using the standard infrared remote control. The indoor unit beeps to
acknowledge the correct transmission of data. If it is not possible to program the indoor unit using the remote
control, it can also be manually operated.
Faults are indicated
by codes (see chapter
Troubleshooting and
customer service).
NOTE
Replace discharged batteries
immediately with a new set in
order to avoid risk of leakage.
It is recommended that the
batteries are removed if the
equipment is shut down for
longer periods.
NOTE
Display on indoor unit
The display illuminates according to the settings. In operation, the display
lights up, the selected mode and the nominal temperature are shown.
Manual operation
The indoor unit can also be started
manually. To do so, press the
button on the right side of the unit
to activate the automatic mode.
In manual operation, the following
settings apply:
Automatic operation:
Above 21°C = cooling operation,
set temperature 24°C
under 21°C = heater operation,
set temperature 24°C
Fan speed AUTO
Press the button on the infra-red
remote control to interrupt manual
operation.
max. 6 m
1 max. distance 6 m
Display on indoor unit
Power
Unit turned on
Air circulation
mode set
Timer operation Fan speed
Stage 1, 2 and 3 and
Auto (blinking)
Display
Display of
coded error
messages, room
and nominal
temperature
C
TURBO
SET
Ion generator
switched on
REMKO ATY
6