REMKO ATY 261 DC - Manual (Page 4)

Safety notes
Disposal of packaging
All products are packed for
transport in environmentally
friendly materials. Make a valuable
contribution to reducing waste
and sustaining raw materials. Only
dispose of packaging at approved
collection points.
Disposal of equipment
and components
Only recyclable materials are used
in the manufacture of the devices
and components,
Help protect the environment
by ensuring that the devices
or components (for example
batteries) are not disposed
in household waste, but
only in accordance with
local regulations and in
an environmentally safe manner,
e.g. using certified firms and
recycling specialists or at collection
points.
Environmental
protection and
recycling
Carefully read this manual before
putting commissioning the
equipment. It provides useful
tips and information as well
as hazard warnings to prevent
injury or material damage .
Failure to follow the directions
in this manual can result in
endangerment to persons, the
environment and the equipment
itself and will void any claims for
liability.
■
Keep this manual and the
refrigerant datasheet near the
unit.
■
The unit may only be set up and
installed by qualified personnel.
■
The setup, connection and
operation of the unit and
its components must be in
accordance with the operating
conditions stipulated in this
manual and comply with all
applicable local regulations.
■
Mobile units must be set up
securely on suitable surfaces
and in an upright position.
Stationary units must be
permanently installed for
operation.
■
Modification of equipment
and components supplied by
REMKO is not permitted and
can cause malfunctions.
■
Equipment and components
may not be operated in areas
where there is an increased
risk of damage. Observe the
minimum clearances.
■
The electrical voltage supply
is to be adapted to the
requirements of the equipment.
■
The operational safety
of equipment and components
is only assured if they are used
as intended and fully assembled.
Safety devices may not be
modified or bypassed.
■
Do not operate equipment
or components with obvious
defects or signs of damage.
■
All housing parts and openings,
e.g. air inlets and outlets, must
be free of foreign objects, fluids
or gases.
■
The equipment and components
must be kept an adequate
distance from flammable,
explosive, combustible,
aggressive and dirty areas
or atmospheres.
■
Touching equipment parts can
result in burns or injury.
■
Installation, repair and
maintenance work may only
be carried out by authorised
specialists. Visual inspections
and cleaning can be performed
by the operator as long as the
equipment is not under voltage.
■
Take appropriate hazard
prevention measures when
performing installation, repair
or maintenance work or
cleaning the equipment.
■
The equipment or components
are not to be exposed to any
mechanical stresses, extreme
levels of humidity or direct
sunlight.
Warranty
In order to make warranty claims,
it s essential that the ordering
party or their representative
complete and return the "certificate
of warranty" and "commissioning
report" to REMKO GmbH &
Co. KG at the time when the
equipment was purchased and
commissioned. The warranty
conditions are detailed in the
"General terms and conditions".
Only the contractual parties can
strike special agreements beyond
these conditions. In this case, first
contact the contractual partner.
REMKO ATY
4