Niveo Professional NGS16TP - Manual (Page 68)

64
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
IGMP function.
For example,
# show mac-address-table multicast
Group VID Group Address Members Port
----- --- --------------- -------------
14. show mac-security command
This command is used to show mac address security settings on port. There are two
mac address security functions for ports. One is “accept” function that allows static
mac addresses on ports to access network only. Another is “limit by mac no.” function
and up to a limit number of mac addresses are allowed to access network from the
port.
For example,
# show mac-security
[MAC Security Configuration]
===========================================================
Port# Max. MAC no. Learned no. Security Control
Eth 1/ 1 0 N/A No Security
Eth 1/ 2 0 N/A No Security
Eth 1/ 3 0 N/A No Security
Eth 1/ 4 0 N/A No Security
Eth 1/ 5 10 0 Limited by MAC no
Eth 1/ 6 0 N/A No Security
Eth 1/ 7 0 N/A Accept function
Eth 1/ 8 0 N/A No Security
Eth 1/ 9 0 N/A No Security
Eth 1/10 0 N/A No Security
15. show management command
This command is used to show switch management security settings. The IP/subnet,
access mode, and protocol functions security settings will be shown.
For example,
# show management
[Management IP configuration]
Index Enabled Address / Net Mask Mode Http Telnet SNMP
====================================================================
1 Yes 0.0.0.0/0.0.0.0 Modify Yes Yes Yes
2 No 0.0.0.0/255.255.255.255 View No No No
3 No 0.0.0.0/255.255.255.255 View No No No
4 No 0.0.0.0/255.255.255.255 View No No No
====================================================================
16. show map command
This command is used to show 802.1P priority, DSCP priority, and port-based priority to