beautypg.com

Niveo Professional NGS16TP User Manual

Page 55

background image

51

NIVEO PROFESSIONAL Gigabit Management Switch

User's Manual

ip address dhcp command is used to enable DHCP client function. DHCP client
function will try to get IP configuration from DHCP server in network. And no ip
address dhcp
command can be used to disable it.

ip address x.x.x.x y.y.y.y command is used to set IP address of the switch on this
VLAN. “x.x.x.x” is the IP address. “y.y.y.y” is the subnet mask.
For example, “ip address 192.168.1.12 255.255.255.0” will set the IP address of the
switch on this VLAN group for remote management.

ip address renew command is used to refresh the lease time of the IP address got by
DHCP. If IP configuration is not got when boot-up, this command will try to get IP
configuration again.

ip address release command is used to release current IP address got by DHCP. Then,
you can try to get the IP configuration again by “ip address renew” command.



8. no command

This command is used to disable a function or restore a setting to factory default of
the switch.

(config-if)# no ?
ip Internet protocol


For example,
ip address dhcp” command can enable DHCP client function on the VLAN group
interface and “no ip address dhcp” command can disable it.

This manual is related to the following products: