Niveo Professional NGS16TP - Manual (Page 34)

30
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
logging remote-log command is used to enable the remote logging function. Events
will also be sent to syslog servers. no logging remote-log command is used to
disable it.
logging remote-log x host y.y.y.y command is used to set IP address (y.y.y.y) to
syslog server with index x. Up to five (x=1~5) syslog servers are supported.
18 mac-address-table command
This command is used to configure functions for Mac address table of the switch.
Entering “mac-address-table ?”, the sub-commands will be shown.
(config)# mac-address-table ?
aging-time Aging time for entries in the address table
static
Sets MAC address table static information
mac-address-table aging-time x command is used to set to aging time of the switch.
The valid value of “x”(aging time in seconds) is 10-1000000 and 0. If x=0, the aging
operation will be disable.
mac-address-table static x-x-x-x-x-x interface ethernet 1/y command is used to assign
a static Mac address x-x-x-x-x-x to Port y of the switch. The static mac address will not
be aging out by the switch.
19 management command
This command is used to setup the management interface security function. The
management interface security function can limit the IP / subnet / remote
interfaces(http,telnet,snmp) / access right(view,modify) for management from
network. Different administrators could have different rights to manage this switch.
This is for security of this management switch. (Four user groups are supported for
this function.)
Entering “management ?”, the sub-commands will be shown.
(config)# management ?
<1-4> Index
(config)# management 2 ?
enable
Set enable for a specified set
ipaddr Set IP and net mask for a specified set
mode Set mode for a specified set
protocol Set protocol for a specified set
management x enable command is used to enable the security settings for some user
groups (“x” is the index of the user group). And no management x enable command
can be used to disable it. And users for this setting are allowed to manage this switch
remotely.
management x ipaddr y.y.y.y z.z.z.z command is used to set the IP/subnet for some
user groups (“x” is the index of the user group, y.y.y.y is the IP address, z.z.z.z is the IP
subnet mask). Users in this IP subnet will belong to this users groups.