Niveo Professional NGS16TP - Manual (Page 31)

27
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
mode.
2. Setting for RADIUS server, use “radius-server” command.
Please refer to sections for the commands.
11
end command
This command is used to exit from configure mode.
12 hostname command
This command is used to set the name of the switch in network. This name is also
used as the hostname for SNMP agent function of the switch.
13 interface command
This command is used to entering interface configuring mode. There are two sub-
commands for it - one is “ethernet”, it is for port setting, another is “vlan”, it is for
VLAN groups characteristics setting.
(config)# interface ?
ethernet Ethernet port
vlan Switch Virtual LAN interface
All the port setting commands are put in interface configuring mode - like rate-limit
setting, speed-duplex setting, .... And characteristics settings for VLAN groups are also
done in interface configuring mode - like IP address assignment.
For example, the console will enter interface configuring mode for Port 5 with
“interface ethernet 1/5” command. And the prompt will become ...
(config)# interface ethernet 1/5
(config-if)#
With “interface ethernet 1/5,6,10-13”, the console will enter interface configuring
mode for Port 5, 6, 10, 11, 12, 13. And all the settings will be applied to those ports at
the same time.
The description of commands in interface configuring mode is put in Section 6.2.4
Interface Configuring Commands. Please refer to the section for the details.
14 ip command
This command is used to configure some IP-depending functions. Entering “ip ?”, the
sub-commands will be shown.
(config)# ip ?
default-gateway
Specifies the default gateway
http HTTP server configuration
igmp IGMP protocol