Niveo Professional NGS16TP - Manual (Page 42)

38
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
6.2.4 Interface Configuring Commands
Commands in Configuring Mode are for general switch settings. And its prompt is
“(config)#”.
The port interface function and VLAN group interface function are set with “interface”
command.
(config)# interface ?
ethernet Ethernet port
vlan Switch Virtual LAN interface
interface ethernet 1/x command is used to configure settings for Port x. Please refer to
section
6.2.4.1 Interface Configuring Commands for Port for the details.
interface vlan x command is used to configure VLAN Group x interface (“x” is the VLAN
ID). Please refer to section
6.2.4.2 Interface Configuring Commands for VLAN for
the details.
Both commands will change the prompt from “(config)#” to “(config-if)#”.
Note: The general VLAN settings are done with “vlan database” command. Please refer
to section
6.2.5 VLAN Configuring Commands for the details. And interface vlan x
command is used to assign characteristics to a VLAN interface. For example, assigning IP
address to a VLAN interface is done with this command.
6.2.4.1 Interface Configuring Commands for Port
Commands in Configuring Mode are for general switch settings. And its prompt is
“(config)#”.
If the settings are for ports, it is done with “interface ethernet 1/x” command in
configure mode. For example, “interface ethernet 1/5” is for settings on Port 5.
Some syntax are supported for port selection.
1. interface ethernet 1/x and “x” is port number. All the settings after this command will
be applied to this port. For example, “interface ethernet 1/5” and all the settings after
this command will be applied to Port 5.
2. interface ethernet 1/x,y,z,... and “x”, “y”, “z",.. are port number. All the settings after
this command will be applied to these ports. For example, “interface ethernet
1/2,4,7” and the settings after this command will be applied to Port 2, Port 4, and Port
7.
3. interface ethernet 1/x-y and “x”,”y” are port number. All the settings after this
command will be applied to ports in this range. For example, “interface ethernet 1/4-
7” and the settings after this command will be applied to Port 4, Port 5, Port 6, and
Port 7. (Port 4~7)
4. interface ethernet 1/w,x,..,y-z and “w”,”x”,”y”,”z” are port number. All the settings