Niveo Professional NGS16TP - Manual (Page 32)

28
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
ip default-gateway x.x.x.x command is used to specify the default gateway for IP
configuration of the switch. x.x.x.x is the IP address of the gateway device.
ip http ... command is used to configure http service of the switch.
Entering “ip http ?”, the sub-command will be shown.
(config)# ip http ?
secure-server Enable secure HTTP server
server Enable HTTP server
ip http secure-server command is used to enable the SSL function of http service
(https) of the switch. And no ip http secure-server command can be used to disable
it.
ip http server command is used to enable http service of the switch. And no ip http
server command can be used to disable it.
Because hacker or worm/virus (like ColdRed) often attacks http server, this
command is provided to enable/disable http service to prevent it. (If this switch is
installed in public Internet without any firewall protection, we suggest users to
disable the http interface and use Telnet or SNMP instead.)
ip igmp ... command is used to configure IGMP operation of the switch. Entering “ip
igmp snooping ?”, the sub-command will be shown.
(config)# ip igmp snooping ?
mrouter
Multicast router
query Enable IGMP query function
query-interval Configures query interval
query-max-response-time Configures the report delay
router-port-expire-time
Configures router port expire time
unregflood Enable IGMP unregister flood function
ip igmp command is used to enable IGMP function of the switch. And no ip igmp
command can be used to disable it.
ip igmp snooping mrouter ethernet 1/x command is used to set the port that
connecting to the IP Multicast router (the IGMP active device). “x” is the port
number.
ip igmp snooping query command is used to enable the IGMP query function. And
no ip igmp snooping query command can be used to disable it.
ip igmp snooping query-interval x command is used to set the IGMP query time
interval if query function is enabled. “x” is the time interval, and its valid value is 60-
125.
ip igmp snooping query-max-response-time x command is used to set the maximum
response time for query operation. “x” is the time interval, and its valid value is 5-25.
ip igmp snooping router-port-expire-time x command is used to set the time interval
of router port expire time. “x” is the time interval, and its valid value is 255-500.
ip igmp snooping unregflood command is used to enable IGMP unregister traffic
flooding function. And no ip igmp snooping unregflood can be used to disable it. If
it is enable, the unregistered (not joined) IP multicast traffic will be flooded to every
port. If it is disable, the unregistered (not joined) IP multicast traffic will be flood to
IGMP member ports only.