Niveo Professional NGS16TP - Manual (Page 38)

34
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
used in 802.1x operation.
Entering “radius-server ?”, the sub-commands will be shown.
(config)# radius-server ?
host Sets the port as a host port
key Sets the RADIUS encryption key
port Sets the RADIUS server network port
radius-server host x.x.x.x command is used to set the IP address of RADIUS Server for
802.1x operation. “x.x.x.x” is the IP address.
radius-server key xxx command is used to set the security key to handshake with
RADIUS Server. “xxx” is the key string.
radius-server port x command is used to set the communication port of RADIUS
Server. “x” is the port number and its valid value is 1~65535.
27 rate-limit command
This command is used to define the unit and operation mode of rate limit operation.
The unit could be 128Kbps to 30Mbps. And the rate limit on each port is done with the
level number of each port multiplied with this unit.
rate-limit unit x command is used to set the unit for rate limit operation. “x” is the
unit number and its valid value is 128-30000. (Kbps)
rate-limit mode command is used to disable “Packet Drop of Ingress Limit” function.
When Ingress traffic rate exceeds Ingress Rate Limit, the switch can drop packets or
pause the traffic. If packet drop is enabled, flow control of ports will be disabled and
packets could be dropped. If packet drop is disabled, flow control of ports will be
enabled and pause frame will be sent when ingress traffic rate exceeds the limit. “no
rate-limit mode” command can be used to enable it.
28 snmp-server command
This command is used to configure SNMP operation of the switch.
Entering “snmp-server ?”, the sub-commands will be shown.
(config)# snmp-server ?
<1-5> Index of Trap
community Defines SNMP community access string
contact
Sets the system contact string
location Sets the system location string
username Sets the snmpv3 user informations
version
Sets the snmp version
snmp-server community get xxx command is used to set the community string of get
command for SNMP operation. “xxx” is the community string.
snmp-server community set xxx command is used to set the community string of set
command for SNMP operation. “xxx” is the community string.
snmp-server contact xxx command is used to set the contact information for this
switch. “xxx” is the contact information string.