Niveo Professional NGS16TP - Manual (Page 25)

21
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
This command will change the console interface to configure mode. And the prompt
will become “(config)#”. In this mode, administrator can do system configuration of
the switch.
The operation of configure mode will be described in next section.
“exit” command can be used to quit this operation mode.
11. copy command
This command is used to backup system configuration/firmware to TFTP server, restore
system configuration from TFTP server, and update firmware from TFTP server.
# copy ?
binary-config Copies binary configuration file
config
Copies configuration file
firmware Copies run-time firmware
copy binary-config running-config tftp xxx.xxx.xxx.xxx yyy command is used to backup
current switch running configuration to TFTP Server at IP “xxx.xxx.xxx.xxx” as file name
“yyy” in binary format.
copy binary-config tftp running-config xxx.xxx.xxx.xxx yyy command is used to restore
binary configuration file “yyy” from TFTP Server at IP “xxx.xxx.xxx.xxx”.
copy config running-config tftp xxx.xxx.xxx.xxx yyy command is used to backup
current switch running configuration to TFTP Server at IP “xxx.xxx.xxx.xxx” as file name
“yyy” in text format.
copy config tftp running-config xxx.xxx.xxx.xxx yyy command is used to restore text
configuration file “yyy” from TFTP Server at IP “xxx.xxx.xxx.xxx”.
copy firmware running-firmware tftp xxx.xxx.xxx.xxx yyy command is used to backup
current running firmware to TFTP Server at IP “xxx.xxx.xxx.xxx” as file name “yyy” in
binary format
copy firmware tftp running-firmware xxx.xxx.xxx.xxx yyy command is used to update
the running firmware file “yyy” from TFTP Server at IP “xxx.xxx.xxx.xxx”.