NewTek 3Play 330 - Manual (Page 32)

Page 26
3. 3P LAY International: Select a Video Standard and Resolution setting appropriate for your
connected sources (see Section 3.4.1).
4. Choose 1-Out as the active Output Mode for this introductory session (see Section 3.4.2).
5. Click Start Session. The 3P LAY Desktop will appear on your screen (Figure 11).
Figure 11
Assuming you have correctly connected the 3P-10 control surface, the standard Desktop will be
shown.
Note: If the Dashboard (Figure 12) appears at lower-right on the Desktop, this normally indicates
that the 3P-10 control surface was not detected on launch. Exit the Desktop by clicking the [x]
Close button at upper-right, remove and reconnect the 3P-10, and open another New Session.
If a connection problem persists, please contact NewTek Tech Support for assistance. (See Section
6.4.9 for information on the Dashboard.)
Figure 12