NewTek 3Play 330 - Manual (Page 21)

Page 15
4 SETTING UP
This chapter explains how to properly connect power, external
control devices, monitors and audio visual sources to your NewTek
3P
LAY ™ system.
It also reviews registration for warranty purposes and technical
support. After completing this short section, you’ll be all set to
continue into the Quick Start chapter that follows it.
To begin, let’s review what is ‘in the box’:
1. 3P LAY system
2. 3P-10 Control Surface and USB cable
3. Keyboard and Mouse
4. A/C power cord
5. 3P
LAY Reference Manual
6. 3P LAY Quick Start Guide
7. Registration reminder card
4.1 COMMAND AND CONTROL
1. Connect an external computer monitor to a DVI or VGA port on 3P LAY s’s back plate
(whichever port is appropriate for your monitor connection type).
Note: As a minimum, 3P LAY requires a Screen resolution of 1280 x 768 pixels for its user
interface.
2. Connect keyboard and mouse to appropriate ports on 3Play’s back plate.
3. Likewise, connect the 3P-10 control surface to a USB port.
4. Connect the A/C power cord from the three-prong connection on 3P
LAY ’s rear to an
external power receptacle.
5. Turn on the computer monitor.
6. Press the Power switch located on 3P
LAY ’s lower front.