Deleting a device, Changing device logging settings – Measurement Computing WiFi-500 Sensor Series User Manual
Page 18
WiFi-500 Sensor Series User's Guide
Deleting a device
18
Deleting a device
Complete the following steps to delete a device and all of its data sessions from the software:
1. Select a device in the
Existing devices
screen (refer to Figure 8 on page 13).
2. Right-click the device image and select
Delete Device(s)
.
3. Click
Yes
in the
Are you sure?
dialog box.
4. Click
Yes
in the
Archive Data
dialog box to save device data to the host computer. You are prompted to
select a location to save the archived data.
Caution! If you are deleting the device in order to update the device firmware, MCC strongly recommends
that you archive your data. All data is deleted from a device during a firmware update (refer to
Click
No
to skip saving device data and finish deleting the device.
Once you delete a device, perform the
Connecting the device to a network
procedure on page 8 to reconnect the
device to the network and access it through the software.
Changing device logging settings
To change the logging settings of a device over the network, select the device and click
Change Device
Settings
in the
Existing devices
screen (refer to Figure 8 on page 13).
Follow the steps at the beginning of the section
Changing device logging settings from the PC
on page 10 to
change the device logging settings over the WiFi network.