Leprecon Litescape dimmer - Manual (Page 33)

QuickStart Procedures—Presets
Litescape User’s Manual, Page 17
C
HAPTER
7: P
RESETS
How to Program Presets from the LWD Control Panel
1 From MAIN MENU press the right arrow key 5 times or until rooms blinks in the display.
2 Press ENTER.
3 The first ROOM will blink in the display. To select a different ROOM in the system, press the up arrow
key until the room number or name is blinking in the display under
ROOM.
4 Press the right arrow key 2 times, passing by the ZONE display, so that the first preset is blinking in
the display underneath the word PRESET.
5 Use the up and down arrow keys to select the preset to be programmed. Press ENTER to select that
preset.
6 Press the right arrow key 7 times or until PRESET PROGRAM MODE is displayed. Use the up or
down arrow key to select edit mode.
7 Press the right arrow key once to set the level for each ZONE. A level for each of 12 possible ZONES
can be assigned to the current PRESET. Use the right and left arrow keys to move from ZONE to
ZONE. Use the up and down arrow keys to modify the level for each ZONE.
8 To program the next preset for the room, press the left arrow key until ROOM and PRESET are
displayed, and the entire name of the preset previously edited is blinking. Use the up or down arrow
to select another preset.
9 When the preset to be edited next is displayed, press ENTER. Continue as in steps 6-8 above.
How to Program a Preset Using a Fader Panel
1 Adjust the lights to the desired levels using faders on the wall panel.
2 Press and hold down the PRESET button on the wall panel that is to be programmed.
3 The preset LED will begin to blink. Continue holding the button down for 8 seconds. If it is released
prematurely, no reprogramming will occur.
How to Temporarily Disable a Wall Panel
Wall panels can be disabled temporarily by turning the key in the KEYSWITCH panel to LOCK, or with
the LWD-2400 menu as outlined below. The 3-pin priority jumper on the back of the wall panel MUST be
set to LOW PRIORITY (shorting plug over lower two pins) before it can be disabled.
1 From the MAIN MENU, press the right arrow key 4 times or until system is blinking in the display.
Press ENTER.
2 Press the right arrow approximately 14 times or until LOW PRIORITY PNL is in the display.
3 The number next to ROOM will be blinking. Use the up or down arrow to change to the room number
for the panel to be disabled.
4 Press the right arrow key once. The first two letters of the word enabled will be blinking (or the first
three letters of disabled if the panel is already disabled). Use the up or down arrow to change to the
state desired.
5 Press ENTER to save the change. Press the left arrow key repeatedly to return to the MAIN MENU.