Leprecon Litescape dimmer - Manual (Page 13)

Installation of the LWD-2400 Litescape™ Dimmer
Litescape User’s Manual Page 11
C
HAPTER
1: I
NSTALLATION OF THE
LWD-2400
Specifications
CHANNELS: 12 independent circuits
LOAD PER CHANNEL: 20 Amps
UNITS LINKABLE: Yes, up to 4 in a networked system (attached to Architectural
panels), up to 32 in DMX only systems
POWER INPUT: 105-124 VAC line to neutral
Three phase (default wiring) 80 amps per leg
Single phase (field convertable) 120 amps per leg
POWER INPUT LOCATION: Bottom or Top
CONTROL INPUT: DMX512, Addressable for Each Pack in System
COOLING: Convection Cooled, 100% Duty Cycle
DIMMING CURVE: Square Law
NON-DIM Programmable Per Channel
DIMENSIONS: 26.5” High x 24” Wide x 6” Deep
WEIGHT: 65 lbs
DISPLAY: LCD 2 line 16 character with backlight
INTERNAL SCENES: 100
CUE PROGRAMMING: Fade, Delay, Link
REAL TIME CLOCK: Day, Hour, Minute, Second
INTERNAL PROGRAMMING: Yes, using menu-based interface
EXTERNAL PROGRAMMING: Console Snapshots
Mounting
The dimmer requires sufficient clearance to allow airflow for cooling. The dimmer is rated to operate at an
ambient temperature of 40 degrees Celsius, or 104 degrees Fahrenheit. The following clearances are
suggested:
Top: 24 inches
Bottom: 24 inches
Right Side: 12 Inches
Left Side: 12 inches
The LWD-2400 is attached to the wall using six screws, at least #10 in size. The mounting pattern is
shown in Fig 1. Note the distance from the top and bottom of the unit relative to the top set of mounting
slots. Install the unit as required to meet applicable safety regulations.
A plywood mounting base is recommended if a suitable mounting surface is not available. Use of all six
mounting screws for proper weight distribution is also recommended.