Legrand DRD6 v2 - Manual (Page 9)

room BinDing
After the House ID is set in the DRD6, you create a room by binding devices to
the DRD6. You can also add the DRD6 to an existing room. When a new DRD6 is
added to a room, its scene buttons execute the same scenes as other room scene
controllers with the same scene set assignment (see MORE SCENES). Paddle
functions are the same at every room scene controller that is bound to the same
room, regardless of scene set assignment.
important: If you are planning to use Groups in the room, you should bind
those devices together before beginning the room binding process. Group
binding instructions are provided with individual devices.
Binding a new room
1. With all devices installed and energized, make sure that every Miro wireless
device LED in the room is green.
2. Press on the DRD6 until its LED flashes yellow (about 2 seconds). You now
have 5 minutes to complete this process.
3. To include or exclude a device press on the device until the LED changes
color. Yellow flashing LED = Included in room
green flashing LED = NOT included in room
If you get to a device and it is NOT flashing, see TROUBLESHOOTING.
4. Return to the DRD6 used in step 2. Press for about 2 seconds — the status
LED stops flashing, then all the status LEDs in the house turn green.
adding a DrD6 to an existing room
If you’re adding a DRD6 in a room where room level scene control is already
operating, the new DRD6 must first acquire the House ID (see Adding a DRD6 to
an Existing Installation). Then it must be bound to the existing room as follows:
1. Press on any previously bound DRD6 room controller or MRH6G room
remote in the room until the LED flashes yellow (about 2 seconds).
2. Verify that the new DRD6 LED is flashing green. All other devices included in
the room are flashing yellow. Press on the new DRD6 until its LED changes
color.
Yellow flashing LED = Included in room
green flashing LED = NOT included in room
3. Return to the same previously bound DRD6 used in step 1 and press until
the LED changes to solid green (about 2 seconds). All device LEDs should be
solid green.