Legrand DRD6 v2 - Manual (Page 3)

trouBLeshooting
During house iD binding, the LeD is not flashing on some devices.
• If LED is solid green before initiating House ID binding:
The device already has another House ID. Reset it to the factory default so
that it can be bound to the desired House ID. Resetting to factory defaults
is described in “I made a configuration mistake. I need to start over.”
• If LED is solid yellow after initiating House ID binding:
The device may be out of range of the initiating device. Add
a MRR2G Wireless Repeater to boost signal range.
During binding or customizing, all LeDs stop flashing before i press .
The 5 minute binding process timer may have expired. Restart the timer
by repeating steps 1 and 2 of the procedure you were using. Notice that
the devices you previously excluded are flashing green; those included are
flashing yellow; simply finish the process from where you left off.
the device LeD flashes red when i press .
The house or room configuration may be locked.
Go to any house level scene controller and simultaneously press and but-
tons B and E until the scene controller LED flashes GREEN.
Go back to the previously locked device and press .
• If it flashes green or yellow, you have unlocked the house configuration.
• If the device still flashes red, the configuration may be locked
by a room level scene controller such as the DRD6 or MRH6G.
Go to the room scene controller and simultaneously press and buttons
B and E until the scene controller LED flashes GREEN. (See LOCK ROOM
CONFIGURATION.)
Go back to the previously locked device and press .
• If it flashes green or yellow, you have unlocked the room configuration.
• If the device still flashes red, the configuration may be locked by another
room level scene controller in the house. Repeat the procedure from dif-
ferent controllers until the device is no longer flashing red.
i made a configuration mistake. i need to start over.
To reset any Miro wireless device to factory default settings, press and
hold - - until the LED changes to solid yellow (approximately 10 seconds).
During the process, the LED flashes yellow. When complete, it becomes solid
yellow. The device can then be reconfigured, exactly like any new device.
CLeaning
Clean using a cloth dampened only with water and a little mild detergent. Use of
solvents or hydrocarbon-based cleaners may cause permanent damage.