Legrand SAF - Manual (Page 4)

NOTE: The Walker Shallow Raised Floor Box should
be used on access floor installations.
Do not use in concrete or wood floors.
Textured Surface
Carpet
Step 9 Make necessary connections to specified
communication jacks (Not supplied). Snap
the supplied bezel into opening followed
by the device. (See Fig. 10.)
Step 10 When the box is not in service, the wire
retainer should be installed (textured side
up) to block off the cable exit. (See Fig. 11.)
Otherwise, any exiting cables should be
routed through the wire retainer prior to
closing the lid. (See Fig. 12.)
Step 11 For carpet installations use the 8 1/16" x 10 1/8"
[205mm x 257mm] carpet blank remaining from
the opening and cut a piece to match the recess
in the cover. Glue the piece of carpet onto the
floor box cover. (See Fig. 13.)
FIG. 10
FIG. 11
FIG. 12
FIG. 13
NOTE: Low voltage cables may be pulled through
a bushing in one of the communication
device plates or may be attached to a
device that is mounted to the plate.
WIREMOLD
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX 905-738-9721
1 002 430R3 0111 © Copyright 2011 Legrand/Wiremold All Rights Reserved