JLCooper ES-SloMoJ - Manual (Page 46)

Power
The ES-SloMoJ requires a 9-12 volt DC power supply capable of
delivering 500 milliamps or more. This can be either from the
power mains using the provided power supply or directly from 9-
12 volts DC. The connector is a 2.1mm coaxial power connector.
The center pin is positive. A power switch on the rear panel turns
the unit on or off.
The unit comes with a power supply appropriate for the country in
which the unit was sold. If you need a power supply specific to
your location, please contact your local distributor or JLCooper
Electronics.
Warning: Using a power supply other than the unit specified could
result in damage to the ES-SloMoJ and/or other equipment, which is
not covered by the JLCooper Factory Warranty.
Location JLC P/N
North America PSDC117
Europe (except UK) PSDC230
Japan PSDC117
JLCooper Approved Power
Supplies
46