Pinout – JLCooper ES-SloMoJ User Manual
Page 45
45
Pinout
ES-SloMoJ to Deck
The table below details the pinout of the cable included with the
ES-SloMoJ.
ES-SloMoJ
Function
Machine
1
Machine
2
Machine
3
Machine
4
Ports
1,2,3,4
Ground
21
11
16
6
1
Receive A
22
25
17
20
2
Transmit B
10
12
5
7
3
Receive B
9
13
4
8
7
Transmit A
23
24
18
19
8
Note: Some decks do not use pin 1 for ground so you may have to
connect pin 1 at each end of the ES-SloMoJ cable to pins 4 and 6 on
your deck.
The data transmission from the ES-SloMoJ follows the standard P2
specification. EIA RS-422A at 38400 bits/sec, 8 data bits, 1 stop
bit and odd parity.
ES-SloMoJ to ES-SloMoJ / ES-SloMoJ to Computer
To connect two ES-SloMoJ controllers together, an RS-422A
crossover adapter or cable will be needed. An adapter is available
from JLCooper Electronics by ordering p/n 620026. An RS-422A
crossover cable can be made by using the following pinout:
1,4,6&9 1,4,6&9
2
8
3
7
7
3
8
2
Note: pins 1, 4, 6 and 9 are grounds and are connected together at
each end.